Monto's Laundry Hamper Assembly

Step 1: Attach the fabric cover to the top frame.

  • Find the hard edge of the fabric cover.
  • Clip this hard edge into the slot along the back of the frame with the two holes.
  • Make sure the logo is centered at the front.

Step 2: Insert pipes and add bottom frame.

  • Take the four metal pipes.
  • Push one pipe into each corner of the top frame.
  • Then, take the bottom part of the frame and place it over the metal pipes.
  • Make sure each pipe goes into the hole at the corner of the bottom frame.

Step 3: Pull the cloth cover over the bottom frame.

  • Pull the cloth cover carefully over the lower frame. You may need to use some force to stretch it evenly.
  • Make sure the fabric is smooth and straight. If it's twisted, adjust the cover before continuing.
  • Once it's aligned, snap the hard edge of the fabric into the slot on the bottom frame.

Step 4: Tighten the bolts and attach the foot pads.

  • Slowly push up the metal pipes to ensure the cloth sleeve is stretched and secure.
  • Use a Phillips screwdriver to tighten the four bolts into the bottom of the frame, ensuring the cloth is stretched and neat.
  • Attach the foot pads to cover the holes.

Step 5: Attach the flip cover.

  • Place the flip cover on the frame in the open position, standing upright.
  • Insert the two pins into the slots on the sides of the frame.
  • Press down to secure it in place.

Step 6: Attach the inner bag.

  • Remove the Velcro and stick it to the inner bag’s fixing ring.
  • Place the handles of the inner bag along the long edge of the fixing ring.
  • Insert the inner bag into the frame to complete the installation.